Hardness Testing

What is Hardness?

Hardness is the property of a material that enables it to resist plastic deformation, usually by penetration. However, the term hardness may also refer to resistance to bending, scratching, abrasion or cutting.

Measurement of Hardness:

Hardness is not an intrinsic material property dictated by precise definitions in terms of fundamental units of mass, length and time. A hardness property value is the result of a defined measurement procedure. Hardness of materials has probably long been assessed by resistance to scratching or cutting. An example would be material B scratches material C, but not material A. Alternatively, material A scratches material B slightly and scratches material C heavily. Relative hardness of minerals can be assessed by reference to the Moh's Scale that ranks the ability of materials to resist scratching by another material. Similar methods of relative hardness assessment are still commonly used today. An example is the file test where a file tempered to a desired hardness is rubbed on the test material surface. If the file slides without biting or marking the surface, the test material would be considered harder than the file. If the file bites or marks the surface, the test material would be considered softer than the file.

The above relative hardness tests are limited in practical use and do not provide accurate numeric data or scales particularly for modern day metals and materials. The usual method to achieve a hardness value is to measure the depth or area of an indentation left by an indenter of a specific shape, with a specific force applied for a specific time. There are three principal standard test methods for expressing the relationship between hardness and the size of the impression, these being Brinell, Vickers, and Rockwell. For practical and calibration reasons, each of these methods is divided into a range of scales, defined by a combination of applied load and indenter geometry.

Hardness Test Methods:

Rockwell Hardness Test
Rockwell Superficial Hardness Test
Brinell Hardness Test
Vickers Hardness Test
Microhardness Test
Moh's Hardness Test
Scleroscope Hardness Test
The Durometer

Hardness Conversion or Equivalents:

Hardness conversion between different methods and scales cannot be made mathematically exact for a wide range of materials. Different loads, different shape of indeters, homogeneity of specimen, cold working properties and elastic properties all complicate the problem. All tables and charts should be considered as giving approximate equivalents, particularly when converting to a method or scale which is not physically possible for the particular test material and thus cannot be verified. An example would be converting HV/10 or HR-15N value on a thin coating to the HRC equivalent.

Hardness Conversion Tables and Charts:

Hardness Conversion Table
Hardness Conversion Chart (1)
Hardness Conversion Chart (2)
Chart of Brinell, Vickers and Ultimate Tensile Strength Equivalents (1)
Chart of Brinell, Vickers and Ultimate Tensile Strength Equivalents (2)
Hardness Conversion Table related to Rockwell C Hardness Scale (hard materials)
Hardness Conversion Chart related to Rockwell C Hardness Scales (hard materials)
Hardness Conversion Table related to Rockwell B Hardness Scale (soft metals)
Hardness Conversion Chart related to Rockwell B Hardness Scale (soft metals)
HV, MPa and GPa Conversion Calculator



© Copyright 2017, Southern Inspection & Testing. All rights reserved.